Файл: BASCOM AVR, help reference (2007).pdf

© MCS Electronics, 1995-2007

Auto backup

Check this option to make periodic backups. When checked you

can specify the backup time in minutes. The file will also be saved

when you press the compiler button.

Auto load last file

When enabled, this option will load the last file that was open into

the editor, when you start BASCOM.

Auto load all files

When enabled, this option will load all files that were open when

you closed BASCOM.

Reset docking

This will reset the dockable windows to the default position.

OPTION

DESCRIPTION

Auto open processor PDF

This option will automatic load the PDF of the selected micro

processor in the PDF viewer. The $REGFILE value determines

which datasheet is loaded. The PDF must exist otherwise it can

not be loaded.

Open PDF in new sheet

Every time you change the value of the $REGFILE the processor

PDF can be shown in the same sheet, or a new sheet can be

shown with the PDF. A good option in case your project uses

multiple processors.

Auto save/load project

Load all PDF's when the project is opended that were loaded

PDF

when the project was closed.

OPTION

DESCRIPTION

Use integrated

Set this option to use BASCOM’s simulator. You can also use AVR

simulator

Studio by clearing this option.

Run simulator after

Run the selected simulator after a successful compilation.

compilation

Program

The path with the program name of the external simulator.

Parameter

The parameter to pass to the program. {FILE}.OBJ will supply the

name of the current program with the extension .OBJ to the

simulator.

OPTION

DESCRIPTION

Programmer

Select one from the list.

Play sound

Name of a WAV file to be played when programming is finished.

Press the directory button to select a file.

Erase Warning

Set this option when you want a confirmation when the chip is erased.

Auto flash

Some programmers support auto flash. Pressing F4 will program the

chip without showing the programmer window.

Auto verify

Some programmers support verifying. The chip content will be verified

after programming.

Upload code and

Set this option to program both the FLASH memory and the EEPROM

data

memory

Program after

When compilation is succesful, the chip will be programmed

compile

Set focus to

When the chip is programmed, the terminal emulator will be shown

terminal emulator

Parallel printer port programmers

LPT address

Port address of the LPT that is connected to the programmer.

Port delay

An optional delay in uS. It should be 0. But on some systems a delay

might be needed.

Serial port programmer

COM port

The com port the programmer is connected to.

STK500 EXE

The path of stk500.exe. This is the full file location to the files

stk500.exe that comes with the STK500.

USB

For mkII and other Atmel USB programmers you can enter the serial

number here. Or you can look it up from the list.