Файл: 92FWD_8H.pdf

Fig. 15 Speed Control Switch Continuity

STOP LAMP SPEED CONTROL SWITCH TEST

(1) Disconnect the six way connector at the stop lamp switch (Fig.16). Using an ohmmeter, continuity may be checked at the switch side of the connector as follows:

Fig. 16 Stop Lamp and Speed Control Switch Wiring

(a)With brake pedal released, there should be continuity:

²Between pin 1 and pin 4

²Between pin 3 and pin 6

²No continuity between pin 2 and pin 5

(b)With brake pedal depressed, there should be no continuity:

²Between pin 1 and pin 4

²Between pin 3 and pin 6

²Continuity between pin 2 and pin 5

(2)If the above results are not obtained, the stop lamp switch is defective or out of adjustment.

Fig. 17 Vacuum Gauge Test

(2)Start engine and observe gauge at idle. Vacuum gauge should read at least ten inches of mercury. Shut off engine, the vacuum should continue to hold 10 inches of mercury.

(3)If vacuum does not meet this requirement, check and correct the following vacuum leaks:

²Vacuum lines

²Check valve

²Vacuum reservoir

²Servo, refer to Servo Vacuum Test

²Poor engine performance

SERVO VACUUM TEST

(1)Remove the speed control cable at the throttle body end.

(2)Disconnect the 4-way electrical connector and the vacuum harness at the servo (Refer to Fig. 12).

(3)Connect battery voltage to pin 2 of the servo.

(4)Ground the remaining three servo pins 1, 3 and

4.

(5)Connect a hand held vacuum pump to the servo vacuum nipple and apply 10 to 15 inches of vacuum.

(6)The cable should pull in and hold for as long as vacuum is applied.

SERVO UNIT

REMOVAL

(1) Remove two nuts attaching speed control cable and mounting bracket to servo.

(2)Remove screws attaching servo mounting bracket.

(3)Remove servo mounting bracket.

(4)Disconnect electrical connector and vacuum

hose.

(5)Pull cable away from servo to expose retaining clip and remove clip attaching cable to servo.

INSTALLATION

(1)With throttle in full open position align hole in speed control cable sleeve with hole in servo pin and install retaining clip.

(2)Connect vacuum hose to servo.

(3)Connect electrical connector.

(4)Position mounting bracket and install screws attaching bracket and tighten to 12 NIm (105 in. lbs.) torque.

(5)Insert servo studs through holes in speed control cable and mounting bracket.

(6)Install nuts, tighten to 7 NIm (60 in. lbs.) torque.

SPEED CONTROL SWITCH REMOVAL

The speed control switch is mounted in the steering wheel and wired through the clock spring device under the steering wheel hub (Fig.1).

WARNING: IF REMOVAL OF AIR BAG MODULE IS NECESSARY, REFER TO GROUP 8M, RESTRAINT SYSTEMS.

REMOVAL

(1)Turn off ignition.

(2)Remove two screws from back side of steering wheel.

(3)Rock switch away from air bag or horn pad while lifting switch out of steering wheel.

(4)Disconnect 4-way electrical connector.

INSTALLATION

(1)Turn off ignition.

(2)Connect 4-way electrical connector from clock spring to switch.

(3)Place switch in steering wheel, sliding the forward edge of switch under air bag or horn pad. Line up locating pins on switch with holes in steering wheel frame.

(4)Attach switch to wheel with two screws starting with the screw at the left end of the switch.